Refill Kit for Zcorp and ProJet x60 Cartridges
Easy to use refill kit for 3D powder based Zcorp and ProJet x60 powder based printers.
Here is a simple, mess-free and reliable solution for refilling your Zcorp and ProJet binder cartridges. The system is based on a syphon principle: the binder runs down into a cartridge by the gravity pull.
- bottle plug
- 60ml syringe
- long tubing (1m)
- short tubing
- fitting for the cartridges (black is for 1L cartridges, grey is for 300ml)
- latex gloves
- 5 o-rings and an o-ring applicator (Color Kit only)
Cartridge TypeClear/Black 1L, Cyan/Magenta/Yellow 300 mL, 2 in 1 (1L + 300 mL), 5 in 1 (1L + 300mL, 5 fittings & tubes)